discussion Fine-line detail - a cheap solution.

[Guest]

To add fine line detail like the louvre vents shown in the picture.

Print the detail on a laser printer (photocopier might work but I haven't tried this). Reverse the image if it is 'handed' or contains text.

Prepare the area to receive the detail to it's final stage prior to varnish.

Trim the paper to a workable size, apply a thin coat of varnish to the image (printed face) and the area that is to take it.

Carefully place the paper face down on the surface (varnish to varnish), align it correctly and then use a roller or similar tool to remove any air bubbles that may be trapped.

When the varnish is dry soak the paper with water and very gently rub it away with a finger. Keep wetting the paper as it comes off and continue to rub until the detail is clearly visible. The paper may become transparent when wet so leave it to dry thoroughly before checking that all the paper has been rubbed away.

When rubbing the paper away it is important to be very gentle as it doesn't take much to go too far and rub away the detail as well.

So far I have only used this method on bare wood and white paint but it should work on almost any hard surface.

A trial on a piece of scrap is always advisable before trying it on your model.

Hope you find this helpful,

Scottie

View attachment 7405

/monthly_2005_01/57272b6d68457_linedetailtip.jpg.78859b0d322eca14a57d60c4adfc8c9e.jpg

View attachment 12100

View attachment 12700

View attachment 125226

 

[wonwinglo]

Scottie,I find this method very interesting and as a variation you could experiment with the thermal ink qualities of these printers,firstly do a fresh photocopy of the design,having prepared the surface with a product called 'Japan gold size' which is available from art shops and suppliers,turn the paper upside down with the design against the models surface,now take a domestic iron and with the tip warm the rear of the paper,carefully peel away the paper which should leave the design on the model.

All that is now needed is to apply a good coat of varnish over the surface.

As with all of these things,experiment on a part of the model that does not show if things go wrong !

This idea can be used to transfer designs from plans to your bare wood as well.

 

[Guest]

I just had to add a commercial plug for a company that I ordered some "water slip decal paper" as they call it. It came next day and their website is worth a look at for special effect stuff, loads of ideas. www.craftycomputerpaper.co.uk . Usual disclaimer but a very satisfied customer.

 

[Guest]

Thanks Duncan, that's the product for me!

Steve.

ps. - do you know what s/ware is best to use to make roundels where you can specify the size as opposed to approximating>