G
I got the idear from this it uses a p.c mouse and a C.D.
The software continuously plots rpm, torque and power and exports curves to excel:clap:
Sci-Spot.com - Dynamometer
I already built a running in rig for new motors or brushes on 130 size motors.
(The motor mounts are from an Xmod and the gears are from a kyosho mini z)
I could test motors measuring the output of the slave on below rig and got some pretty consistant results.
It was then converted (in a rush) to a prototype dyno using a P.C mouse. I only want to compare the motors against each other so the power readings are not true. The software was just adjusted to the motors manufactures specs.
Results:
I tested te same motor over and over and got very consistant results so I am happy it is working ok.
I rebuilt a motor and tested it before and after
All five motors below are the same model
View attachment 28481
View attachment 34062
View attachment 34068
View attachment 147088
View attachment 147094
The software continuously plots rpm, torque and power and exports curves to excel:clap:
Sci-Spot.com - Dynamometer
I already built a running in rig for new motors or brushes on 130 size motors.
(The motor mounts are from an Xmod and the gears are from a kyosho mini z)
I could test motors measuring the output of the slave on below rig and got some pretty consistant results.
It was then converted (in a rush) to a prototype dyno using a P.C mouse. I only want to compare the motors against each other so the power readings are not true. The software was just adjusted to the motors manufactures specs.
Results:
I tested te same motor over and over and got very consistant results so I am happy it is working ok.
I rebuilt a motor and tested it before and after
All five motors below are the same model
View attachment 28481
View attachment 34062
View attachment 34068
View attachment 147088
View attachment 147094