If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
[ATTACH=CONFIG]n1141501[/ATTACH]
I took this pic the other day... I might struggle with this as your perception is that tree bark is brown but here the tree is mainly green!
Jason . Yes it would be , this must be on the wettest side of the tree. Also not in open land so in a damp spot .Here's a few others
All depends on what the tree is.
Thanks all... just been for a rather damp stroll and came up with these which are closest to the bark on the model...
lots of green a red browns in there, plus much darker where it is wet near the base...The
Figure is finished now so I will start with the tree and crack on from there.
Thanks
Jason
Thanks all... not much done today (home schooling!!!).... need to add more leaves especially round the base of the tree and just prepping to add a small stream.... nearly done!
Thanks
Jason
Base is about done... just added an oil was a few more leaves and water effects...
Just trying out creating a few discarded shells from the MP40 by snipping some painted wire.... I hopefully want one splashing into the water but that may or may not come off.??? Thanks
Jason
Thanks Jim....the shell cases aren’t really too visible... but I’m now calling this done!
Not sure if the water effects have worked out either?
Thought I’d take advantage of the frosty weather to get some outdoor shots.
This is a lovely simple kit and I’ve really enjoyed doing it...
Thanks for looking in!
Jason
Comment