Micro Milling/Router bits

[Ian M]

Think i might have found something that resembles something that i could use.

https://www.scalemodelshop.co.uk/tungsten-steel-panel-line-chisel-set-holder-with-5-blades-0-2-0-4-0-6-0-8-1-0mm-p17157/

Thanks for the advice guys

Was just going to suggest these, for once I looked first to see what others have said.

[Tim Marlow]

Was just going to suggest these, for once I looked first to see what others have said.

You don’t want to do that Ian, it spoils the fun :tongue-out3:

[rtfoe]

Hi Alan, I have these router bits from Japan at 0.5 and 0.7 mm. Use them for my figure sculpting mouths and ears.

Haven't seen them anywhere else except upstairs on this corner shop along the main Akihabara road near Yellow Submarine.

Cheers,
Richard aka Wabble

[rtfoe]

I think it's a dental burr.

Cheers,
Richard aka Wabble

[Tim Marlow]

Those are dental burs Richard….open wide….this won’t hurt!

[Tim Marlow]

There are rather a lot of options….
https://www.dentaltix.com/en/blog/gu...es-dental-burs

[Guest]

Those are dental burs Richard….open wide….this won’t hurt!

He uses them for the right application, then.