boatman's 1/72 HMS Tiger C20 build

[BattleshipBob]

Are the brake lights on lol

[boatman]

AN a close up shot an them radars are just bits of scrap balsa at the moment to show what the real radars when i build them will look like

[Jack L]

Looks great Chris, wish I had even a little bit of your electronic know-how!

[boatman]

Are the brake lights on lol

HAHA Bob yea thats a good one as them white running an steamin lights are realy bright but they got to be so i can see them in daylight so i know which ship in mine if a lot of models on the water as i dont want to ram them

[boatman]

Looks great Chris, wish I had even a little bit of your electronic know-how!

HI Jack yea it does help to know a little but im not that great at eletronics as some how it just flows from my fingers must be hidden sections in me ole grey matter that i dont know about till i get doin something like this then it comes out lol
chris

[boatman]

back view with the A/C lights on

[boatman]

AN THE TOP grey section of the mast lifts out just in case its a tight fit in the car

[boatman]

some side veiws shots an the last two ive fitted on two three panel W/T DOORS at the bottom of the mast

[boatman]

that was starboard side above an now port side

[boatman]

[boatman]

[boatman]

AN now some shots of how the rear main mast is now looking but again i'll build the big rardar in the winter as ive got to work out how im gonna stick photo etch togeather but ive already worked out how its gonna go an all the thinkin about how this will be done is all in my mind so no probs till i start it an its 4 " wide quite big by my normal standards

[boatman]

front veiw now with a bit of detail like the back

[boatman]

an a shot OF the A/C lights on low 6v power instead of 12v which when its on the ship they will all be running on 12v D/C

[boatman]

WELL guys thats all for a while as the nxt job is gonna be a nail biter as on friday i will be then fitting in them portholes in the hulls , an the ankors hawers ' an the water intake pipes faceing backwards so if she hits any weed floating on the pond surface they wont hopefully suck it up an block up the inlets as if it does then the big ESC will overheat an burn out an maybe catch fire so to be sure it dont happen im fittin in two water inlets one on each side of the hulls
TTFN
Chris