IWATA Eclipse HP-CS or Harder & Steenbeck Evolution CR plus Two in One

[Guest]

Another H & S user here! I'm opposite to Bob (Bowcat) though, I use the 0.2mm nozzle all the time. With the 0.4 I put too much paint on.
Pete

If found the same Pete, full trigger and it's every where, now resort to the feather light touch and still keep the .4.

[AlanG]

If found the same Pete, full trigger and it's every where, now resort to the feather light touch and still keep the .4.

That's where this little aftermarket life saver comes in. An official Iwata flow control gizmo. Basically fit it. Screw it in/out until you reach the desired maximum flow and there you go. No more guess work every time you pull back on the trigger. Fantastic for doing Luftwaffe mottling

[Guest]

That's where this little aftermarket life saver comes in. An official Iwata flow control gizmo. Basically fit it. Screw it in/out until you reach the desired maximum flow and there you go. No more guess work every time you pull back on the trigger. Fantastic for doing Luftwaffe mottling

[ATTACH=CONFIG]n1112426[/ATTACH]

Ah that's good, very similar to the Evolution H& S where you can set the amount of trigger movement. The thing is I love the Ultra but It doesn't have that lock .

[stillp]

Ah that's good, very similar to the Evolution H& S where you can set the amount of trigger movement. The thing is I love the Ultra but It doesn't have that lock .

Yes, it has that, but I'm just not careful enough when it needs the delicate touch.