G
Still got a Deaths Head Lancer in the figure stash....
G
Jim, it's not the size making up for my .......... :tears-of-joy:
G
Final update for today,
The hydraulic pipes are added - but was a waste of time as only about 1mm can be seen at the top under the armoured cover... New tension hold back braces added to replace the resin offerings. Final details will be added tomorrow and then the major work has been completed and just the hull and turret to finish.
Dry fit time....
Cheers
Mike
The hydraulic pipes are added - but was a waste of time as only about 1mm can be seen at the top under the armoured cover... New tension hold back braces added to replace the resin offerings. Final details will be added tomorrow and then the major work has been completed and just the hull and turret to finish.
Dry fit time....
Cheers
Mike
Love it.
I'm with scottie on this one. Dave
G
Only one pic today...
Busy day today, so only managed to get one side finished with the tie downs... The wire to make them is on the right, with the length required and the bend lines on the metal plate.
Busy day today, so only managed to get one side finished with the tie downs... The wire to make them is on the right, with the length required and the bend lines on the metal plate.
Superb work Mike.
Mike you never disappoint, excellent as always.
G
Cheers Guys,
More pics later today..
More pics later today..
Just had a full read through this build thread Mike. Most excellent work.
G
Thankyou.
G
Update...
So a little more work done to the build...
Swapped out the 'springs' on the drivers hatch and replaced them with better items....
The restraining clamp was rebuilt and the tightening bar added - this works on two clamps one with a right-hand thread and the other with a left hand-thread, so by turning the bar one way loosens and turn the other tightens - simples...
This is the tool box next to the drivers hatch...
3D printed headlights arrived (Thankyou SMM), I added the electrical cable and painted the back of the lamp 'Chrome silver' ready for the painting stage.
And there is the other side.
Final look...
But I have been playing with making my own camouflage net...
Which looks lie this at the end. I will put the process used or if I put it all on here perhaps Ian could move it for you.
Cheers
Mike
So a little more work done to the build...
Swapped out the 'springs' on the drivers hatch and replaced them with better items....
The restraining clamp was rebuilt and the tightening bar added - this works on two clamps one with a right-hand thread and the other with a left hand-thread, so by turning the bar one way loosens and turn the other tightens - simples...
This is the tool box next to the drivers hatch...
3D printed headlights arrived (Thankyou SMM), I added the electrical cable and painted the back of the lamp 'Chrome silver' ready for the painting stage.
And there is the other side.
Final look...
But I have been playing with making my own camouflage net...
Which looks lie this at the end. I will put the process used or if I put it all on here perhaps Ian could move it for you.
Cheers
Mike
G
OMG the detail is on another level I can only dream lol, superb Mike
Mike superb as always
Superb work. Some of the photos bring to mind some kind of giant, mechanical scorpion.
There must be easier ways of hiding from the rent man :tongue-out3:
G
We never used it for that, it was for immediate tools only....
Legal Notice
scalemodelling.co.uk is a privately operated online discussion forum. All content posted by members reflects their own views and opinions and does not necessarily represent those of the forum owners or administrators. While reasonable efforts are made to moderate content, no responsibility is accepted for user-generated material. By using this site, you agree to comply with UK law and the forum rules.