discussion Boatmans 1/200 scale USS HORNET CV8 BUILD AN LIGHTS for the Doolittle raid on japan

[boatman]

 

[boatman]

AN WHILE i was fitting on the top P/E ive gone an bent the bottom P/E AAAAARRRCCCHH so i will have to gently get a small srewdriver an try an gently straighten it out

 

[Bri62]

I tended to struggle with the railings too I remember the Yamato was a nightmare. I feel your pain Chris

 

[BattleshipBob]

Man of your skill Chris, you'll soon sort that out

 

[boatman]

Man of your skill Chris, you'll soon sort that out

HI Bob mate wish i could but at the moment ive left off on the p/e an im tryin to sort out the hangar sides as the destruckions are very vauge an im sittin in livin room with jen an the destruckitions goin back an forth to try an see where im goin wrong an yes now found the probs an to make sure i dont glue them in the wrong place im goin to number them
chrisb

 

[minitnkr]

Always a good plan. Blame the bent rails on careless handling of hawsers.

 

[Jim R]

I am certain you'll sort it and figure out those instructions. As Bob says you have the skill to overcome difficulties.

 

[boatman]

I am certain you'll sort it and figure out those instructions. As Bob says you have the skill to overcome difficulties.

CHEERS Jim im goin to try an just dry fit the parts tomorrow an see if they are the right parts in the right places
thanks for your reply Jim
ATB SIR
chrisb

 

[boatman]

I tended to struggle with the railings too I remember the Yamato was a nightmare. I feel your pain Chris

AN HI Bri yes its enough to get on you with these p/e you try your hardest an when you look at it its bent an a devil to try an staighten out an the nerves are strecheted
chrisb

 

[flyjoe180]

Good progress Chris