discussion Junkers Ju87B-2 ‘Stuka’ Scale 1/24

[Guest]

Once again I'm impressed, each of your models go a step further.

Francesco

 

[Guest]

Hi friends

The Stuka is finished.

Anyway I will continue with this thread posting all the final steps....

After to add the dark green, is time to paint the olive grey colour. And the chipping effect as well.

View attachment 88313


After the painted camouflage I added a very, very dark green wash (enamel).

View attachment 88314


View attachment 201336

View attachment 201337

 

[Alan 45]

Great work mate I can't wait to see the completed plane

 

[Guest]

I used an acrylic white grey colour, thinned with some drops of water, to paint the main winter camo. And then I did the chipping effect again. Once dry, was time for the new tip discover on this build I used this paper as a mask!! And I painted with aged white colour over.

View attachment 88315


This is the result....

View attachment 88316


View attachment 88317


Then I added another wash (enamel), a green/grey colour

View attachment 201338

View attachment 201339

View attachment 201340

 

[Guest]

Advices and mistakes.

Mistake: My mistake was, after applied the dark camouflage, I masked it wrong.... over the dark colour about 0,5 mm (just to safe the light colour was close the dark one, not silver between...) Went I did the chipping effect the lines have appears.

View attachment 88318


Advice: If you have followed this thread, you must see I don’t work with varnish. So the best form to apply a pin wash (for me) is: Take a clean brush and humidify with white spirit. Then “paint” the lines or the rivets. Just wait a moment and then add the dark wash with a very fine brush. If you add so much paint, just wait about 3 or 5 minutes and with another clean brush with white spirit clean the lines. The best product on these moments is the enamels!! If you use an acrylic wash the thinner can damage your previous work and the oils are so slowly to dry... with the enamels and white spirit you don’t will have any kind of problem.

View attachment 88319


View attachment 88321


View attachment 88322


View attachment 88320

View attachment 201341

View attachment 201342

View attachment 201343

View attachment 201344

View attachment 201345

 

[Guest]

The final weathering I did with oils and enamels

Just hope this thread can help or give some ideas at all the people that want to build this model

Thank you very much to all (especially to Steve) for help me during this long way

Thanks again

Polux

You can take a look at the final model here:

http://www.scale-models.co.uk/community/threads/stuka-b2-winter-camouflage.28290/