Woah! Thats very impressive
Colin M's Italeri 1:48 Fiat CR.42 Falco
Collapse
X
-
-
Struts, not exactly a fine art on this kit.
As you can see, they're are all at some amazing angle, which would be ok if they were positively located, but they're not.
Parts 12a and 14a looked like they would support the wing by themselves, even with a poor fit. So that's what I did. They were attached to the upper wing, left to dry for a while, but not fully dry, then forced to make contact with their relevant holes on the fuselage. Then gather a load of paint bottles around the wing to stop it moving, and walk away for two days.
It worked.
My plan is now to slide the remaining struts into place, which should work as they are all at an angle.
👍 6Comment
-
-
👍 3🥰 1😎 1Comment
-
👍 7🥰 2Comment
-
-
-
Cheers Joe. I nearly went with a brown filter, but grey looks to have worked better.
My choice of grey was a bit 'iffy', but it worked.
It was a bit on the bright side before the filter.
In more ways than one. I'm actually flying one of these in Warthunder at the moment, and it's ok.
This is the result of about 4 very thin coats. The first one or two, saw no change. But I was playing careful, with very diluted layers.
Cheers Paul, it was a bit of a slow job.
Thank you all for stopping by. But it's done, all finished. Pictures are in the completed GB section.
👍 2Comment

Comment