boatman's 1/72 HMS Tiger C20 build

[boatman]

It's looking good to me Chris.

HI Sue glad you think so but im not really happy with it but hopefully it will look ok when sprayed grey an thanks for lookin in stay safe
chris

[boatman]

close up shot

[boatman]

strb side shot an these pipes were little buggers to get the right angels before i gluded them in place an had to be carefull with the glue as the funnell must come off

[boatman]

[boatman]

now shots of it mounted on the main 01 deck

[boatman]

[boatman]

an port side angle shot

[boatman]

proper port side shot

[scottie3158]

Chris,
One thing you could try is to put a spring inside the tube to support the walls as you try and bend them. like a plumbers spring. Or nicking the inside of the bend.

[boatman]

an here in the last pic today a shot of this small gantry platform an this was a devil to build but hey it worked out ok an its only 1/4 of an inch depth an talk about fiddley an in case anyone is wondering where the wires are for the Anti /collishion lights they are goin down inside the funnell an at the moment this funnell is a dummy but if i have the room i may buy another smoke unit so both funnells smoke or steam but will see on that

[boatman]

Chris,
One thing you could try is to put a spring inside the tube to support the walls as you try and bend them. like a plumbers spring. Or nicking the inside of the bend.

YES Scottie very good idea on that but this lot is all glued down now but i might try your idea on the front funnel pipes but the bends are so tight i would have loved to done these in brass tubein but i havnt got the bendin tools to do this

[Ian M]

Not sure of the diameter of the pipes, but if you used a bendy straw, i
I'm guessing 6-7 mm? If you can get to a garden centre of flower shop, you can get soft bendy wire covered with a soft 'rubbery ' plastic. Might be something you could use...

[boatman]

Not sure of the diameter of the pipes, but if you used a bendy straw, i
I'm guessing 6-7 mm? If you can get to a garden centre of flower shop, you can get soft bendy wire covered with a soft 'rubbery ' plastic. Might be something you could use...

HI Ian cheers for that idea but ive now only got to fit the front funnel tube an they are very easy an short nothing like the rear ones as by rights the big tubes shoild be about 2mm bigger in diameiter but i think i looks a bit weird to me as its the black tubes standing out against the white funnell plasticard so i think it will all look ok when it in grey an it matches up in colour an looking at the plans these pipes wont be seen much as they will have the seacat missle lauches an the target directors in front of them so no worries
but cheers for havin a look in
an same to all you guys an gals
stay safe
chris

[Mini Me]

Looks fine to me Chris......I do see from the plan sheet beside the funnel that the tubes are larger in diameter, considering what you had to work with, it came out very well. Rick H.

[boatman]

Yep. Looks good to me mate. As Paul says, what aren’t you happy with? May be you’ve been too close to it and need a change Before coming back and finish8ng?

NO thats not the problem Tim its just the pipes should be 2mm bigger in diameter but they will now do as they wont hardly be seen
CHEERS for lookin
chris