I just given my compressor a service worked fine before and now I have reassemble it it no longer fills with air I have looked at you tube videos but I can't see were I have gone wrong I have a weak delivery of air at the airbrush but that's all it's been running for five minutes but still nothing hellllpppp!!!
-
-
Stuck blow-off valve?
Nick -
You did put the water drain plug back in the bottom? lolComment
-
You getting a trickle coming out of the tank before the pipe? What items in this 'service'did you remove/refit? Is there a chance you've put one in back to front. Dos the compressor 'sound normal' when running?Comment
-
There wasn't a gasket/seal between the cylinder head and tank?Comment
-
The brass coloured thin piece of metal which is held in place with a screw needs to lay flat and central over the hole at the other end. If it is slightly curved turn it over.
I think :smiling:Comment
-
Sorted it just took a bit longer as the tank was completely empty all up to pressure and working.Comment
-
Good to hear :thumb2:Comment
-
Worry over - good. Happy airbrushing.Comment
-
Mind you the air tank was half full with brown water no wonder It takes twice as long to fill up.Comment
-
I'm sure you know the moral of this story by now Peter, but drain the tank daily if at all possible.
Mine is starting to make a weird noise, it used to be super quiet, so I think it's time to take the head off again and have a look-see.Comment
Comment