Lovely finish on the exhausts.
1/12 1966 Ford GT 40
- Thread starter Stefee
- Start date
A little more progress.
The engine lid mounted brake cooling snorkels were too horizontal so added 2 mm card to base and sanded the trailing edge back to original level with gentle slope to the front thereby raising the opening 2 mm - hard to see in the photo.
Tarted up the oil filter housing which was open and made provision for connectors and hoses later. filedata/fetch?filedataid=255470
filedata/fetch?filedataid=255469
Carefully opened the louvre vents on the roof and busy now opening the air intakes on the side of the engine clamshell.
Thanks for looking and the reactions and comments.
filedata/fetch?filedataid=255472
filedata/fetch?filedataid=255473
filedata/fetch?filedataid=255471
The engine lid mounted brake cooling snorkels were too horizontal so added 2 mm card to base and sanded the trailing edge back to original level with gentle slope to the front thereby raising the opening 2 mm - hard to see in the photo.
Tarted up the oil filter housing which was open and made provision for connectors and hoses later. filedata/fetch?filedataid=255470
Carefully opened the louvre vents on the roof and busy now opening the air intakes on the side of the engine clamshell.
Thanks for looking and the reactions and comments.
filedata/fetch?filedataid=255472
Legal Notice
scalemodelling.co.uk is a privately operated online discussion forum. All content posted by members reflects their own views and opinions and does not necessarily represent those of the forum owners or administrators. While reasonable efforts are made to moderate content, no responsibility is accepted for user-generated material. By using this site, you agree to comply with UK law and the forum rules.