discussion Airfix1/48 Specialist Spitfire Club edition

[Guest]

Hi everyone, been way to busy this year to pick up anything or even carry on with some in build projects & really wanted to do something so grabbed this off the dust covered shelf earlier....


It does look rather nicely moulded, loads of detail and nice clear instructions to make one of two aircraft


View attachment 254145


View attachment 254146


View attachment 254147


View attachment 254148


View attachment 254149


View attachment 254150


View attachment 254151


View attachment 254152


View attachment 254153

 

[papa 695]

Nice one Dave everyone loves a Spitfire I'm going to watch this.

 

[Guest]

So as usual, circumstances change & what should've been a quick build is going to be the opposite !


Started work on the cockpit last night, the tolerances on these new Airfix kits are very good, to the point some parts won't fit after being painted & need a quick scrape/file to slot back into place.


Im going to let cement dry on these bits then touch up a few areas that need stand may even try belts ( but don't hold me to that !) 

View attachment 254527

View attachment 254528

View attachment 254529

View attachment 254530

View attachment 254531

 

[Guest]

Great progress Dave, looking really good.  Seat belts do make a difference so definitely have a go 

 

[papa 695]

Yes looking very nice Dave

 

[colin m]

A spitfire - nice one.

 

[flyjoe180]

Nice start Dave. Never too many Spitfires

 

[Guest]

Ladies & Gentlemen, I need some advice please.


The comment above about tolerances being really good was just a trap obviously, the top part of the fuselage covering where the oil tank would be sits really proud - don't want to file it down because its 


A, curved - so I'd probably miss shape the profile


B, quite detailed & it would loose that with cutting & filling


So I'm sort of thinking if I sand/file on the lower edges of the part (in third pic) and lower the height of it that way, thoughts?


PS the long fore/aft seam on the top needs to go doesn't it, on all the pictures Ive seen it looks smooth?

View attachment 254622

View attachment 254623

View attachment 254624

 

[colin m]

I agree. I would file the bottom of the part until it sinks into place. Just a bit at a time, test file, test again and again.