Hello Mates! Here is my rendition of the Me 410 Revell-Monogram 1/48 kit. I got half way through and after 10 years on the shelf I thought I would finally finish it and give it away as a gift. Though the kit is perhaps the best out there, it has the well-documented problems of the deformed starboard fuselage, excessive control surface and hinge details and oval air scoops. To get the tail straight, it was necessary to chop off the rear fuselage and re-glue! Even with pre-cut masks, the multi-piece canopy was a nightmare to paint and fit in place. I used Aries detail sets for the cockpit and wheel wells and thin wires to simulate the trim tap control cables and other bits. The paint scheme is quite plain as per photos of the actual aircraft. If I had to do it over, I would put in a little more shading contrast and panel line definition.
Revell-Monogram 1/48 ME 410B
- Thread starter selrach
- Start date
- Status
Nice work
G
Great job! Especially correcting all those problems.
Well it's quite an old kit, but you still made a nice job out of it.
Super work, and a subject not often seen
Good work on this. I always thought it was a great looking aircraft....and your build shows it off nicely.
Good to you Alan with this! I hope it will go a little easier than with me.
Thanks Tim. Marvelous motorcycle. It looks bloody real!
- Status
Legal Notice
scalemodelling.co.uk is a privately operated online discussion forum. All content posted by members reflects their own views and opinions and does not necessarily represent those of the forum owners or administrators. While reasonable efforts are made to moderate content, no responsibility is accepted for user-generated material. By using this site, you agree to comply with UK law and the forum rules.