Theme editor

Scale Model Shop

BOOKNOOK by Rolife Glass House book case insert. Scale unknown

  • Thread starter Thread starter Guest
  • Start date Start date
Thread owner
Continuing with the build, great fun as its so well illustrated instruction wise.

2022_3.jpg2022.jpg2022_2.jpg
The flowers are printed on a sheet, pre stamped cut outs.I just trim down the insert part , spot of glue and in.

Thanks for following.

John.
 
Thread owner
Spent an hr this evening at the bench.

First a set of drawers
2022_6.jpg
made up from this 2022.jpg2022_2.jpg
Dap of glue under the support bar.

2022_4.jpg
Lifting a very thin sticky backed label from here.2022_3.jpg

Next was the plant to the right2022_10.jpg

Made up with a ply surround, then
2022_9.jpg
The white slotted tool is for twisting the plant into a circle so it fits into the wooden tower, then the front was glued in.

More tomorrow, thanks for the comments and for looking in.
John.
 

Attachments

  • 2022_5.jpg
    2022_5.jpg
    7.1 KB · Views: 0
  • 2022_9.jpg
    2022_9.jpg
    7.8 KB · Views: 0
Great Work Mr Race:smiling4:

Looks like an enjoyable build and no fiddly tracks…..can’t be bad :cool::thumb2:
 
Thread owner
More done to day.

2022.jpg2022_2.jpg2022_4.jpg

Bit slow as having to wait for the glue to dry, anyway the first is a completed unit, the plant in photo3 goes into the pot in phonto 2 .
Thanks for following .
John.
 
Thread owner
This afternoon managed this small part but very fiddly.

2022_4.jpg2022_3.jpg2022_5.jpg
The only bit of plastic, so out with the TET .

John.
 
Looking good. Ever thought about scratchbuilding one of these John? Should be right up your street.
 
Back
Top