discussion hobby Boss Il-2 Sturmovik

[Guest]

Breath in Breath out Repeat

Have a jam sandwhich

Martin

 

[Vaughan]

Great advice Martin but do you think that the jam sandwich will hold it all together?

Vaughan

 

[Vaughan]

Well after a 2 month break from this Russian bird I'm back on the case. I finally plucked up the courage to attach the wing mid section to the fuselage. With a lot of brut force and some Mr Cement S it seems to have done the trick. I used this type of glue as it sets very quickly and I couldn't work out a way of holding it in position while a slower glue set. So I glued it section by section and it seems to have worked. There's going to be a fair bit of filling and sanding but it will be worth the effort. I've made a start on the tail planes. Here's a few pictures

Vaughan

View attachment 50888

View attachment 50889

View attachment 50890

View attachment 50891

View attachment 50892

View attachment 163914

View attachment 163915

View attachment 163916

View attachment 163917

View attachment 163918

 

[yak face]

Keep at it vaughan , i cant wait to see this finished , cheers tony

 

[BarryW]

Enjoying this Vaughan. Great job.

 

[Guest]

Vaughan looks like you've minimized the filling quite a bit ,keep up the great work!

 

[Guest]

don't fancy being sat so close to that massive fuel tank.

I hate gaps worst invention ever.

Nice going tho mate

Martin

 

[Vaughan]

I agree with you Martin, seems like a crazy place to put a fuel tank but this bird did have 1.5 tons of armour and a considerable amount around and over the cockpit. The gaps around the wing roots and the logistics of attaching the wings had put me off progressing with the build hence the fact I have built two planes since.

Vaughan

 

[Vaughan]

The Carpet monster Al Fresco!

Well it got far too hot this afternoon in my garden room so no modelling was possible. The next best thing was to go outside. I moved a smaller cutting board, glue, knife and all that I would need to my garden table in the shade on the decking.

All was cool until I started cutting parts off the sprue and dry fitting them. You know where this is going half of a gun stock shot into the air and landed in the gap between the decking and then I stood and watched disappear. Well there was no way round it the decking had to come up. I removed a 10' section and with a torch found it. Decking screwed back down and model back into the safety of my garden room. Lesson learned.

I have managed to start putting squadron filler around the wings and fuselage so some progress has been made. I might get a chance on Wednesday morning before the sun comes round to continue in the relative safety of the garden room.

Vaughan

View attachment 51032

View attachment 51033

View attachment 51034

View attachment 51035

View attachment 51036

View attachment 164058

View attachment 164059

View attachment 164060

View attachment 164061

View attachment 164062

 

[mossiepilot]

Missed the begining of this build, coming along cracking so far.

Must remember there's another monster, the decking monster,LOL

Don't think I'll have to worry too much about losing parts outside, it's hardly stopped raining here for a month.

I'm enjoying watching this come together, and seeing how you overcome each of the problems.

Tony.

 

[Vaughan]

Hi All

Here's an update from over the last week. I've ben working on the wing armament and belt feeds. No real problems here just I had to cut out a section of the wings to accept the machine gun and allow the covers to be added. Yet to close the wing halves and then add to the wing mid section.

Vaughan

View attachment 51423

View attachment 51424

View attachment 51425

View attachment 51426

View attachment 51427

View attachment 164449

View attachment 164450

View attachment 164451

View attachment 164452

View attachment 164453

 

[Guest]

fantastic job mate if my head wasnt sunburnt i`d take my hat off to you lol

mobear

 

[yak face]

Looking good now vaughan , cheers tony

 

[Vaughan]

Hi All here's a further update from over the last three days.

The wing halves are buttoned up and attached to the fuselage only a smear of filler was required, the tail planes are also attached. I removed the tabs on the control surfaces to enable a small amount of droop when they are fitted.

Next step was to fit the wheel well nacelles these came in two halves so had to be glued prior to fixing to the wings some work was required to remove the seams. Once fitted the leading edge needed a fair bit of filler this gave a semicircular join which is not how it appears on the real plane. Unfortunately there's no way of changing the shape so they will have to do.

I have also masked the canopy, I've used the thin strips of tape method and then filled in the centres, all looks good. The canopy was glued to the cockpit area with Clearfix and allowed to set. All seams and joins have been sprayed with grey undercoat to check the finish, all look ok.

Vaughan

View attachment 51562

View attachment 51563

View attachment 51564

View attachment 51565

View attachment 51566

View attachment 51567

View attachment 51568

View attachment 51569

View attachment 51570

View attachment 51571

View attachment 51572

View attachment 51573

View attachment 51574

View attachment 51575

View attachment 164588

View attachment 164589

View attachment 164590

View attachment 164591

View attachment 164592

View attachment 164593

View attachment 164594

View attachment 164595

View attachment 164596

View attachment 164597

View attachment 164598

View attachment 164599

View attachment 164600

View attachment 164601

 

[Vaughan]

Hi All

The canopy,wheel bays,doors and air brakes have been sprayed with the interior colour grey/blue. The fuselage has been pre-shaded in readiness for the top coats of Russian Green and Pale Blue.

I've also made a start on the under-carriage.

Vaughan

View attachment 51657

View attachment 51658

View attachment 51659

View attachment 51660

View attachment 51661

View attachment 51662

View attachment 164683

View attachment 164684

View attachment 164685

View attachment 164686

View attachment 164687

View attachment 164688

 

[Vaughan]

Hi All

Well I'm finally down to spraying this big Russian bird. The underside went down well and the pre-shading looks nice and subtle. Top side has gone on without a hitch the pre-shading has also worked well in breaking up the large areas of Russian green.

I'm having problems with the white metal under carriage the paint is not adhering and just rubs off. This would not be a problem if the under carriage was silver but it is the interior colour Grey/blue. So if anyone has some suggestion I would appreciate it.

Still lots to do Rocket rails, bomb bay doors and all the ordnance to put together, there's lots of it.

Vaughan

View attachment 51806

View attachment 51807

View attachment 51808

View attachment 51809

View attachment 51810

View attachment 164832

View attachment 164833

View attachment 164834

View attachment 164835

View attachment 164836

 

[Vaughan]

A coat of Klear went down last night and I made a start on the decals this afternoon. They are quite basic consisting of two stars on the underside a star on each side of the fuselage and a star plus the number '8' on the rudder and thats the lot. All went down without a hitch.

Vaughan

View attachment 51875

View attachment 51876

View attachment 51877

View attachment 164901

View attachment 164902

View attachment 164903

 

[Vaughan]

Hi All

The under carriage have been primed, painted and weathered and are now fitted. They proved a little fiddly working inside the wheel bay nacelles but I got there in the end. Tyres are also fitted. Trim tab actuators on the tail plane and rudder are now in situ. The rocket rails have been painted and added to the under wings. I still need to make a start on the ordanance.

Vaughan

View attachment 51983

View attachment 51984

View attachment 51985

View attachment 51986

View attachment 51987

View attachment 165009

View attachment 165010

View attachment 165011

View attachment 165012

View attachment 165013

 

[saguy]

coming together very nicely indeed .....rgds lindsey

 

[Vaughan]

Thanks for that Lindsey. I've still got a little way to go yet lots of dangly bits, weathering and a flat coat and of course all that under wing armament.

Vaughan