Theme editor

Scale Model Shop

SimonT - Tamiya 1:35 Sturmmorser Tiger (AAGB)

Thread owner
You could be right Steve - a cunning marketing ploy. Going to be costly throwing 3/4 of it away each time
 
Not the only one Si- I didn’t have to bin half a bottle though! I have had to tweeze a plug of rubbery gunk out of the lid several times. It is a good primer, once de-gunked however.
 
Thread owner
Ah - I just shook my bottle as wasn't expecting that so must have mixed the rubbery stuff into the paint

I shall investigate first next time, thanks

I agree, when it works it goes on nicely
 
Thread owner
stig-117_2020-3-25.jpgstig-118_2020-3-25.jpgstig-119_2020-3-25.jpgstig-120_2020-3-25.jpg
managed to fire up the AirViper0.2 and get a fun couple of hours blasting AK's dunkelgelb modulation set at this one

looks very light but I know it will tone down considerably later on


stig-121_2020-3-25.jpg
the tracks were sprayed with the dark base colour from the modulation set as it looked like a nice starting point

not sure whether to go with camo or leave it plain yellow - i have a german camo modulation set that hasn't been tried yet.......
 
Thread owner
Here you go then.....

stig-125_2020-3-26.jpg
had this set so decided to try it out - three each brown and green shades

had a nightmare trying to get it to spray nicely (I only seem able to get a consistent finish with Tamiya) so the finish is not as good as i would have liked - a bit spattery on the edges

hope to lose some of that with the weathering

stig-122_2020-3-26.jpg
stig-123_2020-3-26.jpg
stig-124_2020-3-26.jpg
the scheme on the side of the box has chips of contrasting colour all over it which looks fun - yellow on the green and brown and green on the yellow areas so may have a stab at that
 
Hi Simon
Paint job looks nice. These sets of paint are a good idea I think. They are cheaper than buying each paint seperately but if you only actually use 5 out of the 6 then your not saving perhaps. Anyway it looks good and even light weathering always subdues the starkness.
Stay safe.
Jim
 
Thread owner
Steven - thanks. Not sure myself but will keep pressing on and see how it turns out

Jim - I have a few of these sets from MigAmmo and AK. Just wish I could get them to spray properly

stig-127_2020-3-27.jpg
made a stencil from thin plastic card and tried spraying the patterns on

only had limited success so ended up hand painting them

stig-126_2020-3-27.jpg
stig-128_2020-3-27.jpg
stig-129_2020-3-27.jpg
all a bit dodgy looking
 
Looking very good Simon. The paint always settles down under a bit of weathering.
 
........ ere`s Smiffy :dizzy:!!!!!
I have a part built, Italeri, one of these on the shelf of shame Simon.......honking great Barrel eh?:surprised::surprised:
Having a good read up and it`s looking lovely mate...... good to see that you`re still going the extra miles on your models:thumb2:,
Cheers,
Andy
 
Hi Simon
That mask you made for the itty-bitty patterns looks to have worked fine. I wonder how that was done in reality. A little man with a pot of paint and a 2 inch brush? :rolling:
Jim
 
Back
Top